phantom won't shoot 250 FPS
Posted 26 December 2010 - 08:52 PM
Posted 09 June 2011 - 07:45 PM
cutting it isn't difficult just be careful not to cut it too much
Posted 30 January 2012 - 05:21 PM
Best thing you can do,
take it apart. Clean and lube the insides lightly. and then drop a few drops of oil (3-4) in the ASA before you air it up. dry fire a few times to cycle the oil through and let the excess blow out the breach (remove your barrel to avoid oil in barrel)
then take the Velocity adjustment and screw it lefty lose a whole bunch, (well at least till its out a bit)
then turn it in and chrono your shots back up.
another thing to note: if the phantom didnt come with detent rings, and its a older style. the barrel is probably a straight 0.690 bore. and with nothing to stop the A-balls from rolling through, you will get roll outs.
This is when the ball either rolls down the barrel before you shoot it, or it partially rolls a bit when you shoot it. Leaving for Whacky velocity issues because the ball never really gets shot from the same position when you push the pump arm back.
Hope this helps
Proudly Partnered With: PBL, Vanguard Paintball, TechPB, Pinokio Hoppers
Posted 03 February 2013 - 11:10 AM
Also keep in mind that getting the marker tuned for co2, HPA, and 12 grams, will necessitate three different settings and retuning. If you need a place to start call up CCI and have a notepad and pen ready and write down everything he says.
OEF Vet 2011-2012, Combat Infantryman Badge Recipient