TechPB Forum: Cocking rod - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Cocking rod covering the breech

#1 User is offline   SwineFluBalla 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 1
  • Joined: 27-July 09

Posted 20 January 2011 - 12:57 AM

i recently got a prostock pump and when i pump it back it back it cocks then it ends up covering the breach how do i adjust the cocking rod?

#2 User is offline   zop1o 

  • megasuperawesomelazerbeamrailgun ofepicdoomandstuff
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 3,582
  • Joined: 23-October 08
  • Gender:Male
  • Location:The snake

Posted 20 January 2011 - 03:41 AM

you may have the wrong size bolt. If it is a 2k5 body you need an evo length bolt, not a standard 2k one but if that is not the case, there should be a little screw in the back of cocking rod. Un do that, just make sure you have a good grip on the that fat piece. Undo that set screw, and then you can adjust the main screw

This post has been edited by zop1o: 20 January 2011 - 03:41 AM

Marq's men founder. flex owner. I AM A MUPPET! C.O.C. member 91. pump/stock players president. Karnivor Owner councilman. Old School Owner. GUN WHORE.
Posted Image
zop1o's marq and auto cocker tuning and repair services
zop1o's feedback2/0/0

#3 User is offline   Mustang 

  • Member
  • PipPip
  • Group: Members
  • Posts: 86
  • Joined: 08-August 10
  • Gender:Male
  • Location:Pampa/Houston Texas

Posted 10 November 2011 - 10:37 PM

You mean the bolt isn't going far enough back to let a ball in? Try unscrewing the back block one or two turns so effectively the bolt goes back farther.
EGO7
Cocker Pump
Angel A1
Tank's Katy Paintball
Unorthodox Paintball Posted Image

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users