TechPB Forum: Spyder Hammer Velocity Issues - TechPB Forum

Jump to content

Help

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Spyder Hammer Velocity Issues

#1 Salvation

Sophomore Member

Group: Members
Posts: 531
Joined: 03-January 09
Gender:Male
Location:Sheridan, IN

Posted 09 July 2010 - 10:30 PM

Ok so I picked up an old Spyder Hammer for cheap. It shoots great but the Velocity is all over the place.

Ive put in new springs but I still get 30+ difference in velocity shot to shot and it tends to shoot hot more often than not. Makes no difference if I run HPA or CO2. I still get the spikes and velocity inconsistancies.

Any suggestions would be greatly appreciated.

Kev

Indiana Member #"Old Fart"
SAS-Indiana
Central Indiana
http://saswoodsball.com/
http://www.sasmilsim.com/

#2 pinkyy

" LL3,4,5vet" LL6 here i come!

Group: Moderator
Posts: 3,243
Joined: 15-June 09
Gender:Male
Location:Brantford Ontario Canada

Posted 25 July 2010 - 06:19 PM

the best i can say is to take the lowest spring you have and cut it, smaller only by a bit, then try it..

To those brave men and women who fought for their lives, who fought to save our lives. We stand at attention in honor of our fallen ones.

Lest We Forget those who fought so hard, never be forgotten. Never take anything for granted, always remember always respect.. ♥

Citrus Connection Scenario Paintball. Me, Crazy Dancing Pink Pant, Crazy Eyed Canadian..

#3 Danny D

Senior Member

Group: Members
Posts: 1,987
Joined: 01-March 10
Gender:Male
Location:Canada

Posted 12 August 2010 - 09:59 PM

Make sure a proper o ring is on the hammer. Buna 70, not buna 90

HOW TO MAKE A BOLT ACTION MARKERBolt Action #1 , Semi SKS Build, Youtube ChannelIf you have G1 or EXTCY issues PM me

#4 Xmas Asn

╭∩╮（︶︿︶）

Group: Members
Posts: 2,184
Joined: 23-April 09
Gender:Male
Location:Barstow, Ca

Posted 17 August 2010 - 04:23 PM

Try a different barrel. I had a Spyder Victor and a mix of bad paint and that cheap barrel I was getting -+20 or 25. Also check your valve and pin. Make sure its clean.