TechPB Forum: GOG ENVY - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

GOG ENVY Solenoid leak

#1 User is offline   Mr Nick 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 2
  • Joined: 25-August 11
  • Gender:Male
  • Location:JHB - South Africa

Posted 25 August 2011 - 08:12 AM

Just looking for some advice,

I have 3 GOG Envy markers that all leak from the solenoid, I have stripped them down and noticed the top section of the solenoid has moved up and an oring is poping out. I tried pushing the oring back and clipped the top section on again but as soon as I air the markers up it just pops that oring back out... is there a way to fix it or should I just replace them???

#2 User is offline   Mr Nick 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 2
  • Joined: 25-August 11
  • Gender:Male
  • Location:JHB - South Africa

Posted 26 August 2011 - 05:49 AM

Ok I have found that the top cap on the solenoids were cracked from over tightning them to the board, hence the reason it kept popping off. I have replaced them and got two working again, now the last one when i air it up the bolt just kicks forward and leaks air down the barrel... any ideas??

#3 User is offline   paul33kane 

  • Sophomore Member
  • PipPipPip
  • Group: Members
  • Posts: 452
  • Joined: 26-September 08
  • Gender:Male
  • Location:barrie ontario canada.

Posted 04 September 2011 - 04:36 PM

does the bolt cycle back or it stays up foward?

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users