[Jarz]

Hey guys, I nabbed a Sheridan XGS today with ASA instead of 12ie changer. I hooked up my HPA tank at home, and I'll get shots that roll out, shots that go maybe 30 feet, then some that are at about 250-ish. Is there any way to fix this?

[Myrkul]

Clean the living piss out of it and try switching to co2. See what that does.

[Jarz]

Myrkul, on 18 August 2012 - 10:37 PM, said:

Clean the living piss out of it and try switching to co2. See what that does.

I'll try. Someone said to get a new hammer spring, but I don't know where to get one.

[Taylor519]

you should post this on mcarterbrown. you will most likely get a lot more help over there.

[Jarz]

Taylor519, on 19 August 2012 - 11:40 PM, said:

you should post this on mcarterbrown. you will most likely get a lot more help over there.

I did, and I didn't get much help. They told me to get a new spring, and that was it.

[russc]

The detent is probably gone. You're getting partial rollouts.

[Jarz]

russc, on 05 September 2012 - 10:42 AM, said:

The detent is probably gone. You're getting partial rollouts.

What detents do they use, or is there a solution?