TechPB Forum: Etha regulator - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Etha regulator

#1 User is offline   Overlord 

  • Member
  • PipPip
  • Group: Members
  • Posts: 138
  • Joined: 14-November 12

Posted 28 July 2012 - 08:45 AM

So I just rebuild my ethas regulator and want to know how much from flush should I turn in velocity adjustment screw?

#2 User is offline   No Mercy Ever 

  • Sophomore Member
  • PipPipPip
  • Group: Members
  • Posts: 534
  • Joined: 05-December 11
  • Gender:Male
  • Location:Federal Way, WA


Posted 28 July 2012 - 11:29 AM

I think that you need to use a chrono to figure that out. It isn't like a LPR, where typically, you get it flush, and then one or two full turns will work out for you.

#3 User is offline   Overlord 

  • Member
  • PipPip
  • Group: Members
  • Posts: 138
  • Joined: 14-November 12

Posted 28 July 2012 - 12:22 PM

Okay I found in the manual that it needs to be 2 1/2 turns in from the al the way out.

#4 User is offline   cybermaniac15 

  • Elite Member
  • PipPipPipPipPipPipPip
  • Group: Members
  • Posts: 5,448
  • Joined: 04-December 10
  • Gender:Male
  • Location:Southern-California

Posted 28 July 2012 - 12:31 PM

It will give you a general idea of what your pressure will be, but you never really know what your fps is until you hit a chrono..
Feedback
http://www.techpb.co...1&#entry1905487
PM8 and Extcy: http://www.techpb.co...pic=215216&st=0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users