TechPB Forum: Bob long cam drive asa wont bleed properly - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Bob long cam drive asa wont bleed properly

#1 User is offline   Pimmen 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 42
  • Joined: 07-June 11

Posted 22 September 2012 - 03:47 PM

i noticed it yesterday when i played with the gun, when i degassed at the end of the day it wouldnt bleed at al so just now i took apart my asa to look at it, and i greased the pin a little bit cause i thought it might have to do with friction or something.
But that didnt help, can it be that i need to service my regulator so ITS pin slides better? its a ninja ultralite adjustible

Skickat från min Galaxy Nexus via Tapatalk 2

#2 User is offline   andrewthewookie 

  • Pull start me and I'm yours ;)
  • PipPipPipPipPipPipPipPip
  • Group: Moderator
  • Posts: 19,444
  • Joined: 22-August 09
  • Gender:Female
  • Location:Your bedroom


Posted 22 September 2012 - 09:03 PM

When you turn off the ASA, do you feel any air coming out the bleed hole at all? Does your regulator purge when you degas with other ASAs?
Posted Image
Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users