TechPB Forum: tank regulator - TechPB Forum

Jump to content

Help

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

tank regulator

#1 TippmannPlayer97

What Doesnt Kill You Simply Makes You... Stranger.

Group: Members
Posts: 520
Joined: 18-December 12
Gender:Male
Location:Lutz, FL

Posted 19 December 2012 - 04:20 PM

i have a pmi 68/4500 tank with what i think is the stock reg. anyways the low pressure (1.8k) burst disk is leaking. i put it in my brothers '11 rail and it started to leak when i pulled it off. why is it doing this? p.s. i think the regulator is loctited or something because no matter how hard i try i cant get the reg off of the tank.

TippmannPlayer97, on 12 May 2013 - 04:08 PM, said:

Crossover 100% its a worlds better marker. the only advantage to the proton would be the board. but since tippmann released the new trigger the crossover is one of, if not THE best marker in the price range

Thats why your trying to get rid of yours right? Damn Newbie XD

#2 Big Walt

Ow Now Brown Cow

Group: Members
Posts: 635
Joined: 06-October 10
Gender:Male
Location:St. Louis

Posted 22 December 2012 - 03:33 AM

You would need a vice to take the regulator completely off the tank. It's possible an o-ring inside is wearing and needs replacing. Are you sure it's the LP disk? Try inverting the tank in a cup of water and see where the bubbles are coming out of the regulator. Could be a much simpler fix.

This post has been edited by Big Walt: 22 December 2012 - 03:34 AM

cockerpunk, on 13 January 2011 - 10:24 AM, said:

i dont shoot them, i greet them in the nude and invite them into my house to talk about jesus.

Feedback 1/0/0
Ball out til you fall out

#3 TippmannPlayer97

What Doesnt Kill You Simply Makes You... Stranger.

Group: Members
Posts: 520
Joined: 18-December 12
Gender:Male
Location:Lutz, FL

Posted 24 December 2012 - 11:11 PM

I literally felt the air coming from the lp disk. Could i just tighten it down or leave it alone? Once i fill to full capacity it shouldnt have low pressure right?

TippmannPlayer97, on 12 May 2013 - 04:08 PM, said:

Thats why your trying to get rid of yours right? Damn Newbie XD

#4 TacticlTwinkie

*insert witty title*

Group: Members
Posts: 3,652
Joined: 02-August 11
Gender:Male
Location:Surf City, USA

Posted 24 December 2012 - 11:33 PM

If you fill it, air will come out of the burst disk if it is indeed blown. You need to replace it. It goes off if there was a spike in output pressure. They are pretty cheap, most paintball shops should have them for under $5 each.