making my own phantom pump handle?

TechPB Forum: making my own phantom pump handle? - TechPB Forum

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

making my own phantom pump handle? help!

#1 notjustapaintballer

'balloholic

Group: Members
Posts: 478
Joined: 16-June 09
Gender:Male
Location:DePue, Illinois

Posted 12 August 2012 - 09:23 PM

so I recently purchased a used phantom, and while I'm anxiously waiting for it to get here, i decided i wanted to buy a cci/wevo UC kit but make my own handle because i dont particularly like how the cci handle looks. so i have a few questions:

i went on mcmaster to look at delrin, but i have no idea which type to get! help? mcmaster <<<<< link
i need to know what tools ill need and what size taps ill need for pump threading etc
What should the diameter of the delrin be?

Any ideas suggestions and help would be greatly appreciated!

This post has been edited by notjustapaintballer: 12 August 2012 - 09:48 PM

my feedback

#2 cockerpunk

a man of fine taste

Group: Moderator
Posts: 8,686
Joined: --
Gender:Male

Posted 12 August 2012 - 10:20 PM

the pump rod is 10/32 UNF, normal delrin will work fine, and whatever size delrin you want. delrin is also known as acetal, delrin is a tradename.

This post has been edited by cockerpunk: 12 August 2012 - 10:20 PM

The ultimate truth in paintball is that the interaction between the gun and the player is far and away the largest factor in accuracy, consistency, and reliability.

sticktodrum, on 19 November 2010 - 02:44 PM, said:

And yes, Gordon is the sexiest manifestation of "to the front."

#3 notjustapaintballer

'balloholic

Group: Members
Posts: 478
Joined: 16-June 09
Gender:Male
Location:DePue, Illinois

Posted 13 August 2012 - 10:35 AM

I found the delrin on mc master, I just didn't know if it made much of a difference whether I chose super wear resistant delrin, normal delrin, glass filled delrin, etc. Thank you for the information cocker punk!

my feedback