TechPB Forum: g6r help - TechPB Forum

Jump to content

Help

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

g6r help

#1 5ozofpain

FUS RO DAH

Group: Members
Posts: 3,792
Joined: 13-September 10
Gender:Male
Location:San Diego, California

Posted 16 November 2012 - 11:50 PM

so my g6r has a problem. once i start to walk the trigger fast, it wont stop shooting even once a let go of the trigger. its not the trigger or anything because this only happens with air on.

Feedback I GEARBAG SALEEKK ELITE

#2 andrewthewookie

Pull start me and I'm yours ;)

Group: Moderator
Posts: 19,438
Joined: 22-August 09
Gender:Female
Location:Your bedroom

Posted 16 November 2012 - 11:54 PM

Sounds like your trigger is bouncing.

Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer

#3 5ozofpain

FUS RO DAH

Group: Members
Posts: 3,792
Joined: 13-September 10
Gender:Male
Location:San Diego, California

Posted 16 November 2012 - 11:56 PM

andrewthewookie, on 16 November 2012 - 11:54 PM, said:

Sounds like your trigger is bouncing.

how do i fix it? and it only does it when air is in if that changes anything

Feedback I GEARBAG SALEEKK ELITE

#4 andrewthewookie

Pull start me and I'm yours ;)

Group: Moderator
Posts: 19,438
Joined: 22-August 09
Gender:Female
Location:Your bedroom

Posted 17 November 2012 - 12:06 AM

Yes, that's normal. It's the recoil of the gun's bolt that is causing the trigger to trip the microswitch on its own. Either increase pre-travel, move the activation point further away from the microswitch, increase the tension, or a combination of all three.

This post has been edited by andrewthewookie: 17 November 2012 - 12:06 AM

Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer

#5 kingJurzy

TechPB's best member 2012

Group: Members
Posts: 7,718
Joined: 04-January 12
Gender:Male
Location:Bay Area, California

Posted 17 November 2012 - 12:08 AM

5ozofpain, on 16 November 2012 - 11:56 PM, said:

andrewthewookie, on 16 November 2012 - 11:54 PM, said:

Sounds like your trigger is bouncing.

how do i fix it? and it only does it when air is in if that changes anything

Yes you have a bouncy trigger.

Make sure you have a good spring tension and back out the trigger so it is not a hair pull. Adjust it so it is farther away from the switch and adjust the set screw all the way on the bottom of the trigger out so you have a longer trigger pull.

Lime, on 04 May 2013 - 08:45 PM, said:

Dude, I wouldn't pay anymore than tree fiddy for a kingjurzy.

FEEDBACK: 20/0/0