[BenPlu2]

I wanted to know if anyone had an easy way of building a stock class tube out of PVC that would fit a clamping feedneck. It also needs the speed feed thingy that won't let the balls come rolling out.
If you have a cheap one for sale tell me in this BST thread:
http://www.techpb.co...howtopic=201085

[Klub]

[BenPlu2]

Klub, on 06 August 2012 - 09:26 PM, said:

Thanks man, do you think that if I used a normal elbow with coupler to thinner diameter pipe I could get it to fit clamping?

[piranha]

I didn't like how big PVC was so I used 3\4 inch copper pipe a 3\4 inch elbow and a rubber chairleg tip cut out with a rubber band through it as the feedgate...cost like ten or twelve bucks and holds 13 balls

[NotaSniper]

piranha, on 07 August 2012 - 10:53 AM, said:

I didn't like how big PVC was so I used 3\4 inch copper pipe a 3\4 inch elbow and a rubber chairleg tip cut out with a rubber band through it as the feedgate...cost like ten or twelve bucks and holds 13 balls

I did the same. I made two. One horizontal, and one at 45 degrees.

[BenPlu2]

Thanks guys! I'm going to build one and tell you how it comes out

[BenPlu2]

piranha, on 07 August 2012 - 10:53 AM, said:

I didn't like how big PVC was so I used 3\4 inch copper pipe a 3\4 inch elbow and a rubber chairleg tip cut out with a rubber band through it as the feedgate...cost like ten or twelve bucks and holds 13 balls

Could you be more specific on the rubber band feedgate?

[piranha]

Actually since then ive made it better, i now use a rubber wire, i can post pics if youd like

[BenPlu2]

piranha, on 24 August 2012 - 09:26 PM, said:

Actually since then ive made it better, i now use a rubber wire, i can post pics if youd like

That would be helpful:)

[piranha]

 WP_000125.jpg (89.06K)
Number of downloads: 7

I took a generic rubber chairleg cap you can get one at lowes or home depot or something and cut the end off with heavy duty scissors

Then i put two holes in the top with my drill

Then took a piece of (i think its 10 guage) wire and bent it in half and stuck it through the holes

then stick it on the copper pipe and viola your done

wouldnt include multiple pics in the samepost :/ but i hope you get the idea

would only let me include one pic but i hope you get the idea

[BenPlu2]

piranha, on 25 August 2012 - 03:52 PM, said:

WP_000124.jpg WP_000125.jpg WP_000125.jpg

I took a generic rubber chairleg cap you can get one at lowes or home depot or something and cut the end off with heavy duty scissors

Then i put two holes in the top with my drill

Then took a piece of (i think its 10 guage) wire and bent it in half and stuck it through the holes

then stick it on the copper pipe and viola your done

wouldnt include multiple pics in the samepost :/ but i hope you get the idea

would only let me include one pic but i hope you get the idea

This helped alot, thanks1

[etekgirl27]

http://www.amazon.co...rds=sock+holder