TechPB
Help
I watched your video on the DM9 when you took it apart and was wondering because I have a leak on the LPR. On the small screws below the LPR I only have the first two screws. The two closer to the back. there is a leak coming out of the one that does not have a screw. And when i cover that hole the little hole right next to it starts leaking out of that then. Any suggestions?
Page 1 of 1
DM9 Leaking! DM9 Leaking around the LPR
#2
RoastedSteak 
- Member
-
- Group: Members
- Posts: 57
- Joined: 14-November 12
Posted 10 April 2012 - 02:26 PM
Im not a real expert with the internals but make sure you have the shim stack assembled correctly
Or
Make sure your lpr is adjusted correctly
Or
Replace the 2 O-rings on the Lpr body?
If you'd like to try these stuff feel free if your feeling some doubt check the Dye forums im sure some techs wonder there like once a week or so
Or
Make sure your lpr is adjusted correctly
Or
Replace the 2 O-rings on the Lpr body?
If you'd like to try these stuff feel free if your feeling some doubt check the Dye forums im sure some techs wonder there like once a week or so
Share this topic:
Page 1 of 1