[marceldacs]

Ok so four things that i got from my teammate today and have questions for all items. Also let me know if it was a good deal.

1. Dye I4 mask- Bought for $50. not heavily used as it was only purchased two months ago. The lens is dirty from paint so how should i clean it? Would running water on both sides be fine? I am worried that water will get in between the lenses. The right ear flap is also disconnected because the glue wore out. Which glue would work for gluing the ear piece back on.

2. halo too w/ epic speed feed. bought for $25. I was wondering if i could take apart the disassemble the speed feed by separating the plastic and rubber, and then use the rubber part as a speed feed for my rotor. Also, how do i turn down the tension settings on the too because as soon as i approached higher rates of fire, i got chops. My rotor didn't do this so i suspect it is something with the too.

3. Hk army headband- $20. How should i wash this in a washing machine? Would a delicate wash in cold water with detergent be okay and air drying.

4 boss bolt w/ spring kit (the black one, not sure of name) - $15, I have the pressure at 170, velocity adjuster two turns out, and the gun is shooting 280. if i set the velocity adjuster at 1.5 and pressure at 150 like i am supposed to, then the velocity will be too low.

This post has been edited by marceldacs: 20 January 2013 - 01:21 AM

[Pbmcdev]

1. If its the foam I would use hot glue but if its an ear I would use super glue.
2. It should say in the manual but there are videos on youtube that should help you. That's how I figured mine out. I'm not sure if there is a tension setting I think there is only speed,microphone and ball-stack
3. Put it in the washing with the rest of your gear and air dry it. Works like a charm. I usually do it with cold water.
4. Don't have an axe sorry

[PREDATOR 47]

1. Run water on the front, wipe with damp cloth on the back side. You don't want to get water in between the lenses. Super glue for ears, hot glue for foam.

2. I don't think the rubber epic part will work as a rotor speedfeed, but if it does, that would be pretty damn cool. As for the loader, check the manual. If you don't have one, it can be found here. http://www.paintball..._Too_manual.pdf

3. Washing machine, delicate setting, cold water, let it air dry, works great.

4. Just turn out the velocity adjuster until you get the desired velocity, it shouldn't hurt anything.

[marceldacs]

ANd is it normal for the boss bolt not to slide smoothly on the bolt guide? It is easier to slide than the stock but it makes a zip sound when you slide it.

This post has been edited by marceldacs: 20 January 2013 - 04:29 PM

[PREDATOR 47]

If it's a delrin bolt, and I believe it is, then yes the slight zipping sound is normal.