TechPB Forum: Automag Barrel - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Automag Barrel

#1 User is offline   obft 

  • Sophomore Member
  • PipPipPip
  • Group: Members
  • Posts: 437
  • Joined: 06-August 11

Posted 29 December 2012 - 05:17 PM

Just a quick question, how do I take a standard automag barrel on and off? Just bought a 68 off Ebay and I love it so far.
My Feedback: http://www.techpb.com/forum/index.php?showtopic=187800&st=0&p=2837225&hl=+obft's%20+feedback&fromsearch=1&entry2837225

#2 User is online   riddler 

  • Junior Member
  • PipPipPipPip
  • Group: Members
  • Posts: 978
  • Joined: 23-August 09
  • Gender:Not Telling

Posted 29 December 2012 - 05:57 PM

Twist about 45 degrees, usually in the direction opposite your feed hole, and slide it on out.

#3 User is offline   obft 

  • Sophomore Member
  • PipPipPip
  • Group: Members
  • Posts: 437
  • Joined: 06-August 11

Posted 29 December 2012 - 06:09 PM

Ok, thank you, I was making it much more complicated than it needed to be.
My Feedback: http://www.techpb.com/forum/index.php?showtopic=187800&st=0&p=2837225&hl=+obft's%20+feedback&fromsearch=1&entry2837225

#4 User is online   riddler 

  • Junior Member
  • PipPipPipPip
  • Group: Members
  • Posts: 978
  • Joined: 23-August 09
  • Gender:Not Telling

Posted 29 December 2012 - 06:42 PM

All good. When in doubt, take the body off the rail (the retaining pin is in the rail).

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users