[paintballguy2255]

Are all cocker grip frames compatible?Because I currently have a cocker with a busted grip frame and it seems as though nobody sells cheap slider frames,so can I put a hinge frame on it?
Or does anyone know where I can get a cheap slider frame?

[riddler]

Yes. And good luck. After years of hinges and e-blades being the frames of choice, many 'cocker owners have come to remember the magic of the slider. These days, they're commonly priced at $50+.

Just note that you'll likely have to swap your 4-way outputs to the ram.

[cocker addict]

customcockers.com or mcarterbrown.com is where you need to go to find used sliders. Some companies are still making new ones like Benchmark but you pay for it.

[paintballguy2255]

Thanks to both of you.Also,does anyone know if it is possible to run a 12 gram changer straight into the vertical ASA?I heard somewhere that it would take some fiddling to get right,but could be done.

This post has been edited by paintballguy2255: 06 January 2013 - 12:28 PM

[riddler]

Definitely possible, though you may need to swap valves/springs.

[paintballguy2255]

nvm,apparently PBgateway is very helpful in this case
Also,Where could I get a stick feed that could be fit on a right-feed cocker?Or do I have to use brass tubing and pipe solder

This post has been edited by paintballguy2255: 06 January 2013 - 12:39 PM

[riddler]

PPS sells one for $40. You could probably build your own for a lot less, but it might not be as pretty.

[paintballguy2255]

I am considering scrapping this cocker.I had planned on fixing it up,using it some,then selling it.But it would be one expensive little bitch.It would cost about $100 to fix up,which leaves no room for profit.
At least I still have my sniper

This post has been edited by paintballguy2255: 06 January 2013 - 12:50 PM

[madsnipes]

i would just build a ghetto stick feed

[paintballguy2255]

madsnipes, on 12 January 2013 - 11:27 AM, said:

i would just build a ghetto stick feed

I already have one.It consists of a small length of PVC piping and a 45 degree elbow.If I sell this one,I could use that money and get a trilly,then proceed to upgrade the shit out of it uselessly.

[Demon]

don't get a trilly you can't really upgrade them. can't get any spring kits for it which is a big thing, or new valves.

[paintballguy2255]

Yeah,I am really indecisive as to what to do about this.I could spend the extra money and fix it,or sell it and be happy cause I actually have money.I may just cast her aside for now.