TechPB Forum: Stop Etek 4 trigger from wobbling without major modification? - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Stop Etek 4 trigger from wobbling without major modification?

#1 User is offline   AviatorMan 

  • Member
  • PipPip
  • Group: Members
  • Posts: 57
  • Joined: 09-December 12

Posted 28 December 2012 - 05:40 PM

With the adjustment screws, I can firm up it's front-back movement to the point of being switch-like, but it wobbles from side to side slightly and I can't figure out how to stop it through adjustment. Is there a way to stop this without major modification?

#2 User is offline   WiscoBaller 

  • Master Member
  • PipPipPipPipPipPip
  • Group: TechPB Players Club
  • Posts: 2,655
  • Joined: 11-August 10
  • Gender:Male

Posted 30 December 2012 - 06:38 PM

I know the etha had the card trick you could do, unsure if the etek4 mounts the same way, but if it does, just look up the etha card trick for the trigger.
University of Wisconsin Whitewater Paintball Club
Sponsored by KEE, H2 Paintball, Empire
The Hooligans Paintball Team
Bob Long Victory Ripper Dye Rotor Dye Throttle 70/4500
Bob Long Ripper FST

#3 User is offline   junits15 

  • And now I am become death, destroyer of worlds
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,692
  • Joined: 30-January 11
  • Gender:Male
  • Location:The YOUnited STATES of 'MERICA

Posted 08 January 2013 - 07:40 PM

you can use Mylar shims
Posted Image
Borg you will NEVER be forgotten.
TECHPB FEEDBACK IOG FEEDBACK
I bought an Ion.... in hindsight it was a bit of an Impulse buy

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users