[XWileyCoyoteX]

Hey guys, any empire trracer bolts other than stock worth looking into to increase preformance?

[HU Soldier]

I dont even think they make after market bolts for it.

[GeezusPB]

HU Soldier, on 21 November 2012 - 01:45 PM, said:

I dont even think they make after market bolts for it.

[misterkyle]

even if they did, changing the bolt on a nelson really wouldn't do much.

[Tick]

Just machine your own or modify it.

[The Inflicted]

There was a user on here and on Mcarterbrown named Lizard_13 who made a run of stainless steel aftermarket bolts for the Trracer.
They didn't increase performance, but they were less susceptible to wear along the lip where the sear latches on.
You might try contacting him or watching eBay or the classified ads. Occasionally one pops up.

http://www.mcarterbr...racer-bolt.html

This post has been edited by The Inflicted: 24 November 2012 - 01:13 PM

[XWileyCoyoteX]

Are there any internals that increase performance?

[BURN177]

XWileyCoyoteX, on 25 November 2012 - 10:30 AM, said:

Are there any internals that increase performance?

not really there isn't very many parts in it. what exactly are you looking for out of it?

[The Inflicted]

XWileyCoyoteX, on 25 November 2012 - 10:30 AM, said:

Are there any internals that increase performance?

There are.
The Trracer is what is referred to as a "Nelson clone," one of hundreds of paintball guns patterned after the original Nelspot pistol.
There aren't that many left these days (Phantom, Hammer, Gargoyle, etc) but in the late '80s and early '90s dozens came out every month and the aftermarket was full of different parts that could fit them.
In general, compatibiltiy across the platform was/is very high, though not absolute.
If you look hard enough you can still find parts like these, but there's no garuntee they would actually increase your Trracer's performance. A lot of these upgrades were designed to shot consumption off a 12-gram, so the way the parts work together can be important. Therefore, an aftermarket TASO power tube, say, may not work that well with a LAPCO fluted hammer, and so forth.

Here are good places to start:

http://www.airsoldie..._Code=OLDSCHOOL
http://www.baccipain...rts/nelson.html

[Fytox]

IMO, don't dump money into the traccer. Sell it get a phantom then proceed to spend millions upgrading it.

[get.lit.up!]

Fytox, on 27 November 2012 - 08:40 PM, said:

IMO, don't dump money into the traccer. Sell it get a phantom then proceed to spend millions upgrading it.

exactly why I'm getting a CCM now