TechPB
Help
Today I was using my Axe. As soon as I started playing I noticed that my first shot or two was shooting at the correct FPS but after that the balls would decrease in velocity until eventually the balls wouldn't have enough pressure to leave the barrel, they were just roll outs. I tried relubing, adjusting the regulator, resetting boards, and I'm stumped at what the problem would be and how to fix it.
Page 1 of 1
Empire Axe
#2
Soundwave 
- I win paintball.
-
- Group: TechPB Players Club
- Posts: 638
- Joined: 11-February 10
- Gender:Male
- Location:Melbourne, Australia
Posted 09 January 2013 - 10:56 AM
Ok, first thing with mini clones is that you never want to adjust the regulator. Leave it at 180-190 psi and never adjust it.
I'm assuming that your tank was full, try this for me:
If you de-gas then re-gas the marker, does the velocity spike back up again?
I'm assuming that your tank was full, try this for me:
If you de-gas then re-gas the marker, does the velocity spike back up again?
#3
Demon
- Master Tech
-
- Group: Members
- Posts: 2,069
- Joined: 22-September 10
- Gender:Male
- Location:Omaha Nebraska
-
Posted 13 January 2013 - 04:08 AM
put a new battery in. put the reg to 180 psi and turn the back cap all the way in and then take it 2 and 1/2 turns out. see what happens. and make sure you lubed the bolt shaft o-rings
TechPB-Mike, on 04 February 2011 - 12:50 AM, said:
this is borderline pornography.......(bookmarks thread)
Captain of the Westside Paintball TeamMy Feedback
Share this topic:
Page 1 of 1