[reflexowner]

Would it be possible to mount a stock and a longer barrel on to a goblin solo
For the barrel I was thinking a PVC pipe molded on to the front but I have but I have no idea how to mount a stock
Btw I trying to make it look like one of those old single shot Winchester

[madsnipes]

using PVC pipe as a barrel...


but seriously i don't think this could work out very well.
however if it does work then that would be pretty cool

EDIT : found this http://www.mcarterbr...o-launcher.html

This post has been edited by madsnipes: 16 January 2013 - 10:42 PM

[Phoenix01]

I'm not entirely certain how much material is left at the end of the goblin solo's barrel, but the goblin duece does have enough for cocker threading and it has been done before.

This post has been edited by Phoenix01: 17 January 2013 - 12:02 AM

[SWAT3050]

I have 3 goblins and can tell you that adding more than an inch or 2 will not work. The amount of air that a cartridge holds is just enough to shoot your paint at about 260-270 FPS. When you add barrel length you are increasing the amount of air needed to propel the ball thus meaning you need to turn up your velocity, but you can't with a goblin shell.

That is why their Duce is only a small amount longer. If there were to come out with longer barrel products later on I think they will have to increase the cartridge lengths to fit more c02 to account for barrel size.

Hope this helps.