TechPB Forum: etek 3 lt leak - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

etek 3 lt leak

#1 User is offline   ADPedro77 

  • Your Friendly Latino
  • PipPipPipPipPip
  • Group: TechPB Players Club
  • Posts: 1,219
  • Joined: 06-October 11
  • Gender:Male
  • Location:Detroit, MI

Posted 31 July 2012 - 03:42 PM

Well aired up my gun today (cause I posted it on the BST section) and found that there is a little leak coming come under the bolt near the ram. I don't know exactly where its coming from but its so faint i didn't hear it at all this past weekend when I went out and played. It still shoots like a beast. All the o rings look good. I checked the noid it looks okay even tho i didn't take it part (i dare not too) the ram looks okay, the LPR looks fine except there is a o ring that looks too small to be there but the manual says its suppose to. Any ideas?
I Don't Care If You're Under 18 And Pay For Your Gear, I'm 21 And My Mom AND GIRLFRIEND Buy Me Paintball Gear. (I HAVE a Job ;) )

#2 User is offline   Soundwave 

  • I win paintball.
  • PipPipPip
  • Group: TechPB Players Club
  • Posts: 638
  • Joined: 11-February 10
  • Gender:Male
  • Location:Melbourne, Australia

Posted 03 September 2012 - 03:53 AM

Without hearing the leak ourselves, it's hard to say. But try changing your exhaust valve and see if that makes a difference. You should have been given one in your parts kit.
Posted Image

My Moderator Application: http://www.techpb.co...howtopic=196721

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users