Empire Trracer Bolts
Posted 21 November 2012 - 01:45 PM
Posted 24 November 2012 - 01:12 PM
They didn't increase performance, but they were less susceptible to wear along the lip where the sear latches on.
You might try contacting him or watching eBay or the classified ads. Occasionally one pops up.
This post has been edited by The Inflicted: 24 November 2012 - 01:13 PM
Posted 25 November 2012 - 08:44 PM
The Trracer is what is referred to as a "Nelson clone," one of hundreds of paintball guns patterned after the original Nelspot pistol.
There aren't that many left these days (Phantom, Hammer, Gargoyle, etc) but in the late '80s and early '90s dozens came out every month and the aftermarket was full of different parts that could fit them.
In general, compatibiltiy across the platform was/is very high, though not absolute.
If you look hard enough you can still find parts like these, but there's no garuntee they would actually increase your Trracer's performance. A lot of these upgrades were designed to shot consumption off a 12-gram, so the way the parts work together can be important. Therefore, an aftermarket TASO power tube, say, may not work that well with a LAPCO fluted hammer, and so forth.
Here are good places to start: