TechPB Forum: G3 L7 bolt Engine problem - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

G3 L7 bolt Engine problem

#1 User is offline   CrayonColors1 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 3
  • Joined: 14-November 12

Posted 14 May 2012 - 05:21 PM

I put in my new L7 engine with and when i shoot it the first shot goes no where or it just gets stuck in the barrel and has i keep shooting the velocity increases . My dwell is at 9. Is it because I have to break it in? or is there some i have to do in my virtue board? somebody please help

#2 User is offline   TK-421 

  • Me So Horny! :D
  • PipPipPipPipPipPipPipPip
  • Group: BST Moderator
  • Posts: 24,927
  • Joined: 29-August 09
  • Gender:Male
  • Location:Austin, Texas

Posted 14 May 2012 - 05:28 PM

Raise your dwell up, you can't lower it immediately, you have to get it broken in before you can lower your dwell. And make sure it's well lubed.
Posted Image
TBC PA DPOC BST Ads 16/0/0

#3 User is offline   CrayonColors1 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 3
  • Joined: 14-November 12

Posted 14 May 2012 - 05:49 PM

how high should i put it like 12 or 13

#4 User is offline   TK-421 

  • Me So Horny! :D
  • PipPipPipPipPipPipPipPip
  • Group: BST Moderator
  • Posts: 24,927
  • Joined: 29-August 09
  • Gender:Male
  • Location:Austin, Texas

Posted 14 May 2012 - 05:52 PM

I think the stock is 14, try it at that
Posted Image
TBC PA DPOC BST Ads 16/0/0

#5 User is offline   andrewthewookie 

  • Pull start me and I'm yours ;)
  • PipPipPipPipPipPipPipPip
  • Group: Moderator
  • Posts: 19,679
  • Joined: 22-August 09
  • Gender:Female
  • Location:Your bedroom


Posted 14 May 2012 - 07:02 PM

The lowest possible dwell I could get my G3 to run consistently on with the bolt engine was 10ms, and that was right after I lubed it. I usually bumped it up to 11ms just to be safe.
Posted Image
Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer

#6 User is offline   CrayonColors1 

  • Newbie
  • Pip
  • Group: Members
  • Posts: 3
  • Joined: 14-November 12

Posted 14 May 2012 - 07:19 PM

Alright thanks for the help

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users