TechPB
Help
does any one know if the 9.1 back block will fit/work on the older t9???
Page 1 of 1
t9.1 back block
#2
SWAT3050 
- TechPB MilSim Tester
-
- Group: Members
- Posts: 586
- Joined: 20-August 09
- Gender:Male
- Location:Tampa, Florida
-
Posted 01 September 2010 - 06:00 PM
No, it has the air through gun capability. Also, among other things the bottom right screw on the T9.1 is an air screw and has a o-ring on it. The T9 doesn't have this air fitting.
"A soldier will fight long and hard for a bit of colored ribbon." -Napoleon-
Kickin Ass And Takin Names The American Way
"Whatever you are, be a good one." -Abraham Lincoln
Kickin Ass And Takin Names The American Way
"Whatever you are, be a good one." -Abraham Lincoln
#4
SWAT3050
- TechPB MilSim Tester
-
- Group: Members
- Posts: 586
- Joined: 20-August 09
- Gender:Male
- Location:Tampa, Florida
-
Posted 01 September 2010 - 06:51 PM
No problem my friend. Feel free to mssage me with any more questions you might have.
"A soldier will fight long and hard for a bit of colored ribbon." -Napoleon-
Kickin Ass And Takin Names The American Way
"Whatever you are, be a good one." -Abraham Lincoln
Kickin Ass And Takin Names The American Way
"Whatever you are, be a good one." -Abraham Lincoln
#5
JeffdeFlatulent
- Newbie
-
- Group: Members
- Posts: 39
- Joined: 09-January 09
- Gender:Male
- Location:NJ
Posted 25 November 2010 - 11:41 PM
I have a related question, I was sort of wondering the same thing but I was wondering if there was a way to convert or swap out the necessary internals to essentially convert a T9 to a T9.1? I want to run HPA in my marker but running it through the magazines is really not ideal at all. I hoping there is someway to covert the T9, rather than having to buy the T9.1. Thanks
Share this topic:
Page 1 of 1