[Test Dawg G]

Hey so i've had my trracer for a while and while it works well i would really like to upgrade to a bottomline. I haven't found any kits made specifically for this purpose. Basically i need help on how to bottomline an Empire Trracer.

[Klub]

all you need is an asa, a reducer and macroline. Put the asa on the frame and put the reducer in the back air asa.

[HU Soldier]

http://www.ansgear.c...tomlinekit8.htm there u go

[Test Dawg G]

HU Soldier, on 23 December 2011 - 06:17 PM, said:

http://www.ansgear.c...tomlinekit8.htm there u go

Does that work with the trracer? Like would the braided hose fit to the back? Thanks

[Klub]

Yes it would

[Test Dawg G]

Klub, on 24 December 2011 - 01:30 AM, said:

Yes it would

K thanks that sounds great i'll order it as soon as i get the chance.

[HU Soldier]

ya but ive seen some that used macroling instead. havent been able to find one yet. im looking for one for mine

[Klub]

If you want to use macroline, get this and an asa. Put some fittings on it and you are set.

[The Inflicted]

Macroline will work, but because of the length of the hose and the fact that it's exposed and will likely get pushed around, stainless is a better choice for this application.
That Archon kit is a great deal.

[Test Dawg G]

Ok thanks again for all you help i think i'll get the braided hose one because i spend alot of time hiding in bushes when i use my trracer so i don't want it to get snagged by the macroline. I'll probably put electrical tape around the hose to "camouflage" it a little.

[The Inflicted]

Test Dawg G, on 25 December 2011 - 04:41 PM, said:

I'll probably put electrical tape around the hose to "camouflage" it a little.

Heat-shrink tubing works well for this, but it can be hard to find in a diameter large enough to slip over the hose fittings.
Electrical tape can look very good too if, especially if you stretch it tightly and take your time as you wrap it.

[Test Dawg G]

So i got the kit, but it doesn't fit to the gun yet. The hose is long enough i believe, but the asa doesn't fit the correct way, its both upside down and backwards. Any tips for how rotate the asa?
Never mind i got it

This post has been edited by Test Dawg G: 15 January 2012 - 10:50 PM