[Kking4321]

I just received my Macdev clone about 2 weeks ago. Leaked right out of the box =/. The
leak is coming out of the bottom of the regulator where you adjust the hpr preassure
there is a o ring in there so i replaced it twice still with no luck its still leaking. I also
contacted macdev two different ways and still no response so if anyone has some ideas
let me know ill give them a try.

Thanks

[vzmaniac]

Kking4321, on 05 October 2010 - 02:43 PM, said:

I just received my Macdev clone about 2 weeks ago. Leaked right out of the box =/. The
leak is coming out of the bottom of the regulator where you adjust the hpr preassure
there is a o ring in there so i replaced it twice still with no luck its still leaking. I also
contacted macdev two different ways and still no response so if anyone has some ideas
let me know ill give them a try.

Thanks

try heavily lubing that oring on the brass velocity adjsuter...

then try turning the red reg seat over you may have a bit of dirt dust on it.... finally pull apart your asa assembly and heavily lube it....

[True Colours]

If its a screw take it out and put teflon tape on it, Then screw it back in.