[ZachPB]

Is it autococker thread? I am looking at ansgear and it doesn't say if it is autococker thread it just says bore size and length.

[BDidz]

If you are looking at a barrel like this(the dual carbon) http://www.ansgear.c...rrel_s/2171.htm you have to purchase the backs and ans only has .689 and .692 they can be found here http://www.ansgear.c...elbackac692.htm and here http://www.ansgear.c...elbackac689.htm

The sly Pro Merc and the sly Anex barrels dont require backs and the SLY Pro-Merc Diesel barrel includes backs.

This post has been edited by BDidz: 21 November 2011 - 09:23 PM

[ZachPB]

BDidz, on 21 November 2011 - 09:22 PM, said:

If you are looking at a barrel like this(the dual carbon) http://www.ansgear.c...rrel_s/2171.htm you have to purchase the backs and ans only has .689 and .692 they can be found here http://www.ansgear.c...elbackac692.htm and here http://www.ansgear.c...elbackac689.htm

The sly Pro Merc and the sly Anex barrels dont require backs and the SLY Pro-Merc Diesel barrel includes backs.

Okay thanks I have a TechT iFiT kit so I can use that. thanks

[BDidz]

NOOOOOOO YOU CANT LOL

I dont think you can without geting a back because you need a autococker threaded pice to thread into the i fit and then into your gun.

This post has been edited by BDidz: 22 November 2011 - 08:06 PM