Barrel size.. One size fits most
Posted 26 October 2012 - 09:33 PM
Posted 26 October 2012 - 10:52 PM
Posted 26 October 2012 - 11:24 PM
Anger leads to hate, hate leads to suffering, and suffering leads to the darkside...
On a more serious note, do you know roughly what bore size the paint in your area runs? I like to underbore that number by a little bit to make sure of no rollouts.
This post has been edited by o-baller: 26 October 2012 - 11:30 PM
98% of statistics in peoples sigs are made up
Posted 27 October 2012 - 12:46 AM
PUMPPB.COM TIGHTSTICK - Custom LAPCO 1-piece underbore barrel! SALE!
PUMPPB.COM - Pump paintball forums
HawaiiPB.com - Paintball forums for the state of Hawaii
HawaiiPB/PumpPB - Our videos
Posted 28 October 2012 - 07:44 PM
I usually use a .682 or .679 Freak insert in my Deadlywind Fibur barrels. I highly recommend them, they allow you to match the paint on the day and conditions. They are expensive and worth it.
If you are looking a one-piece barrel, the best is the LAPCO Tightstick. It is a 14” stepped barrel with a long10” .681 control bore, great porting and a great Tommy machine-gun look as well. They run about 46 bucks (including shipping) or less than half what a Deadlywind Fibur with a couple inserts.
If you can only spend $40, or do not like the look of the Lapco Barrel, then look at the Lurker Barrel, it is 14”, .678 bore (a bit tight for an only barrel), it has a 9.5 inch control bore, very good quality, very light weight, looks like crap.
If you want to spend only 30 bucks, then you are likely looking at the CP .685, not a bad choice, but if you can spend an extra 10 or 20 bucks, you have some better choices.
Posted 29 October 2012 - 01:49 PM
Please feel free to private message Me if you have a question about something i posted
If you show me an inch, I'll show you the dead-box.
Pump/Stock Players Clan
Posted 29 October 2012 - 03:42 PM
Posted 03 November 2012 - 04:05 AM
Breech sizers work great to prevent roll-outs, they do little to improve consistency or efficientcy.
This post has been edited by David A.: 03 November 2012 - 04:06 AM
Posted 04 November 2012 - 06:25 PM