TechPB Forum: Lubed oring question - TechPB Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Lubed oring question

#1 User is offline   marceldacs 

  • Junior Member
  • PipPipPipPip
  • Group: Members
  • Posts: 956
  • Joined: 14-November 12
  • Gender:Male
  • Location:Chicago,IL

Posted 11 February 2013 - 04:44 PM

If an oring gets in contact with dow 33, will the dow 55 not work on the oring?

#2 User is offline   andrewthewookie 

  • Pull start me and I'm yours ;)
  • PipPipPipPipPipPipPipPip
  • Group: Moderator
  • Posts: 19,460
  • Joined: 22-August 09
  • Gender:Female
  • Location:Your bedroom


Posted 11 February 2013 - 04:58 PM

No, everything will still be perfectly fine.
Posted Image
Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer

#3 User is offline   BurningPlaydoh 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,718
  • Joined: 02-December 12
  • Gender:Male
  • Location:Twin Cities, MN

Posted 11 February 2013 - 05:03 PM

View Postandrewthewookie, on 11 February 2013 - 04:58 PM, said:

No, everything will still be perfectly fine.

This.

Just calm down about the G6R; there's no reason you had to make 3 threads. Check and relube the orings and body seals near any leaks with Dow 55 and use the lowest output pressure on your tank.

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users