Posted 16 December 2012 - 03:14 PM
Posted 16 December 2012 - 03:29 PM
I had this problem once before. I bent it back straight, but in doing so created an angle downward, and it still wouldn't pump. I pushed the handle back up so instead of being an obtuse angle from the barrel, it was straight again and this worked, and is still working now.
That being said, what you are at risk of is ruining the guide rod, and the pump handle. both parts that (in comparison to other things) are pretty cheap to replace.
All stock parts (and a few aftermarket/additional things) can be found at CCI's factory website, and you can call in your order.
the website and number are below
CCI Factory Website
Mike Casady will be who is contacted if you call (the man behind it all, he is the one who hand assembles and tests the guns before he ships them out)
The item numbers of the pieces are as follows
#24 - Pump $17 (USD)
#25 - Bolt rod with Nut $5.35 (USD)
Hope this helps, if you have any more questions feel free to ask on the forums or shoot me a Private Message here on the forums
This post has been edited by The-Phantom: 16 December 2012 - 03:31 PM
Please feel free to private message Me if you have a question about something i posted
If you show me an inch, I'll show you the dead-box.
Pump/Stock Players Clan