Just picked up an OG Quest. It is in very good condition but I have noticed a strange issue. It's in semi right now. Has 2.2 Inoviq board. Sometimes, with or without air, when you pull the trigger it will go off multiple times. At first I thought it was bounce but I can get it to do it without air too. Sometimes I can mess with it for an hour and not get it to do it. Sometimes first pull it does it. Replaced battery, havn't gotten to far into the board programing yet. Any ideas?
Update, downloaded the inoviq manual in the "Quest Information Thread" only to find that my quest does not have that flash version. It looks identical to the board in the picture. Where can I get a manual? It's program mode is mcuh different. All I want to do is reset the thing to see if my issue goes away. It will be my semi only shooter anyway.
This post has been edited by NotaSniper: 13 May 2012 - 02:05 PM
TechPB
Help
