Axe vs Axe offered two axes which one to take?
#1
Posted 01 January 2013 - 10:46 PM
They are
1. a black axe with 4 cases through it, no shockwave board and no aftermarket stuff
2. a silver (kinda like this except the entire gun is the color of the barrel. It is a silver color) gun with 14 cases through it. My teamate told me it is like a rarer color or something. This one has a shockwave board and a CP aftermarket feedneck and he said something like an upgraded spring.
The first one has been used a lot less since it is my teamates backup and the silver one he recently required from a trade where it used to be someoneelses main. Is 14 cases considered a lot of abuse? Which one would be a better choice. The silver one is also smoother. Would there be anything bad about getting the silver one because it is older?
#2
Posted 01 January 2013 - 10:52 PM
I would go with the silver seeing as they both are older models with no shockwave boards and because the silver Axe is smoother.
Abuse is throwing your marker in the fireplace after you dunk it into a public pool. Normal shooting is not abuse.
Lime, on 04 May 2013 - 08:45 PM, said:
FEEDBACK: 20/0/0
#3
Posted 01 January 2013 - 10:52 PM
My feedback- http://www.techpb.co...howtopic=217960-
#4
Posted 01 January 2013 - 10:55 PM
#5
Posted 01 January 2013 - 10:58 PM
marceldacs, on 01 January 2013 - 10:55 PM, said:
Just the shockwave board and the back cap print. The newer models do not have the turn direction on the back cap in letters.
Lime, on 04 May 2013 - 08:45 PM, said:
FEEDBACK: 20/0/0
#6
Posted 02 January 2013 - 12:08 AM
kingJurzy, on 01 January 2013 - 10:58 PM, said:
didn't they also change something to do with a feedneck? i thought the first run was having issues with weak feednecks.
This post has been edited by LUXOR54: 02 January 2013 - 12:08 AM
Set-up: Black/gold E2 Karnivor, Dye rotor, Guerrilla air 68/4500, CP 14" .685, Black/Gold Dye I4's, Dye core pads, Venomwear, Etek3 LT. Orange 2k5 superstock, CCM'd
Proud Canadian citizen
#7
Posted 02 January 2013 - 12:29 AM
#8
Posted 02 January 2013 - 01:46 AM
This post has been edited by marceldacs: 02 January 2013 - 02:36 AM
#9
Posted 02 January 2013 - 04:08 PM
#10
Posted 02 January 2013 - 10:23 PM

Help















