Karnivor reg leaking
Posted 07 October 2010 - 06:20 PM
Then its probably an oring on the piston or somewhere in the reg. If you already did that it might be your reg seat.
edit: but put a few drops of oil in the asa, air it up and shoot about 20 times it might stop the leak.
This post has been edited by TheGuy: 07 October 2010 - 06:20 PM
Posted 07 October 2010 - 06:29 PM
Well before you tear it apart put a few drops of oil in the asa then screw in the tank and dry fire about 20 times. The oil getting pushed through the gun may fix the leak. If not unscrew the reg from the body then remove the retaining clip on the bottom with needle nose pliers. Unscrew the adjustment nut and remove the brass piece and change the oring and put on a coat of oil or grease. Reassemble and you should be good.
Posted 07 October 2010 - 07:18 PM
There should be a little circle thing with two holes by where it seperates. If you see it you will know. And if it looks stretched out replace it. I dont know the exact size just use one that fits. And for oil any 100% silicon oil or paintball gun oil. No firearm oil or 3 in 1.
Posted 07 November 2010 - 07:17 AM
See below, black magic and karnivor are internally the same.
What I do to get the top "half" off is get a vice but with wood 2x4's in between the jaws then clamp the threaded part that screws into your gun in between the wood and either strap wrench the bottom half off or if your lucky you can get it off with your hands. Also if you are leaking out of the bottom you need to replace the o ring on the brass part that comes out when you remove the retaining clip and remove the allen screw that adjust the pressure. and as for the leak out of the vent hole you need to replace the oring on the piston.
This post has been edited by mjohns: 07 November 2010 - 07:25 AM