What do you do?
#1
Posted 31 August 2012 - 03:58 PM
** i am just curious, i did not put oil in my fill nipple or know of anyone who has**
#2
Posted 31 August 2012 - 04:21 PM
Awarded: " the biggest dumbass on this forum" 2012
#3
Posted 31 August 2012 - 04:46 PM
If it's still full:
Wash out the area with soap and water. Try to get it out as much as possible (hopefully the Pressure in the tank keeps the nipple sealed)
Degass the tank via firing or ASA
Take apart fill nipple and inspect area. Look for any clues of oil and such.
Probably take the tank to Hydro if I suspect that any oil actually made it into the tank.
If it's empty:
Higher chance oil is actually in the tank. I'd just take it to a hydro place and explain the predicament. They can remove the reg and see for sure if there is oil in the tank or not.
And yes, it's not like one drop and you get a bundle of TNT. It takes a decent amount. However, care should always be taken.
Markers: PGP, Pump Trillogy, Tippmann 98, Bob Long Protege, VSC Phantom
Hoppers: Pinokio, Revy, Winchester
Tanks: 13/3000 Ninja, 68/4500 PE Mask: JT Flex 8
#4
Posted 31 August 2012 - 05:07 PM
#5
Posted 31 August 2012 - 05:11 PM
This post has been edited by MZinCamo: 31 August 2012 - 05:11 PM
#6
Posted 31 August 2012 - 08:48 PM
#7
#8
Posted 31 August 2012 - 09:12 PM
Set-Up: Marq Rapper, Dye Rotor, Ninja 68/45
Be a Brick Wall, Don't Break Down
#9
#10
Posted 31 August 2012 - 09:43 PM
PBNation Feedback 14/0/0 TechPB Feedback 2/0/0 | My Paintball Gun History
#11
#12
#13
Posted 01 September 2012 - 01:13 PM
2. Clean the fill nipple thoroughly with soap and water.
3. When the tank is empty, take apart the fill nipple and clean it again.
4. Don't let any idiots with oil come near your nipples again.

Antonious, on 23 December 2011 - 04:37 PM, said:
My Gearbag Sale!
#14
Posted 01 September 2012 - 01:25 PM
But what you should do is just empty the tank (You can still use it but don't refill it) and remove the fill nipple and buy another.

Using autobid shows you're compensating for something....
#15
Posted 01 September 2012 - 01:26 PM
nighthunter, on 01 September 2012 - 01:13 PM, said:
2. Clean the fill nipple thoroughly with soap and water.
3. When the tank is empty, take apart the fill nipple and clean it again.
4. then just take it because hey, it's a free tank. and with the owner being dead it's not like he's going to stop you...
fixed
Set-up: Black/gold E2 Karnivor, Dye rotor, Guerrilla air 68/4500, CP 14" .685, Black/Gold Dye I4's, Dye core pads, Venomwear, Etek3 LT. Orange 2k5 superstock, CCM'd
Proud Canadian citizen
#16
Posted 01 September 2012 - 02:42 PM
#17
Posted 01 September 2012 - 02:49 PM
My feedback- http://www.techpb.co...howtopic=217960-
#18
Posted 01 September 2012 - 02:51 PM
This isn't "rocket surgery" fellas, think of your car tires. If I filled your car tires with a mixture of fuel oil, kerosene and hydrogen... what would you do? Fix it in your garage? No, you're bring it to a tire store, and have them clean and inspect it
It goes back to the same saying- Problem solvers, or problem finders
A problem finder would try to fix it themselves, or come up with some other stupid way of accomplishing nothing, like leaving it aired up in their closet while they ask for help on the "interwebz"
A problem solver would drain the tank, look at the label, see who the manufacturer is, and call them to get an RMA number... and ship it in
#19
Posted 01 September 2012 - 03:03 PM
TechPB-Mike, on 01 September 2012 - 02:51 PM, said:
This isn't "rocket surgery" fellas, think of your car tires. If I filled your car tires with a mixture of fuel oil, kerosene and hydrogen... what would you do? Fix it in your garage? No, you're bring it to a tire store, and have them clean and inspect it
It goes back to the same saying- Problem solvers, or problem finders
A problem finder would try to fix it themselves, or come up with some other stupid way of accomplishing nothing, like leaving it aired up in their closet while they ask for help on the "interwebz"
A problem solver would drain the tank, look at the label, see who the manufacturer is, and call them to get an RMA number... and ship it in
Hm I've never heard of rocket surgery lol.
My feedback- http://www.techpb.co...howtopic=217960-
#20
Posted 01 September 2012 - 04:44 PM
Quote
This church put this up on their sign
Quote

Help
























