Clone GTi Valve

#1 PaintJunkie

Newbie

Group: Members
Posts: 42
Joined: 28-February 13

Posted 13 March 2013 - 11:18 PM

Anybody following the clone GTi valve? I'm not sure of how much a diffrence it will make, does anybody have any more info on it?

What I Rock:
Marker: Clone GT/Etek4 Pooty style
Mask: Grill/i4
Hopper: Spire/Rotor
Deadmau5 beanie

#2 CrewNYC

Newbie

Group: Members
Posts: 14
Joined: 01-November 11
Gender:Male
Location:Queens, NY

Posted 11 April 2013 - 01:29 AM

I currently received the GTi valve and upon initial testing, I did not see a drastic increase. My velocity did not increase much between the stock GT Valve and the new GTi Valve. To be fair though, the stock valve is a bit broken in and the GTi valve is brand new so I'll have to revisit this again at a later time. Hope to have a video up on YouTube sometime within the week showing the initial test. Not going to say it's not worth it just yet thought.

One more thing is the shot feel wasn't that much different either.

#3 CrewNYC

Newbie

Group: Members
Posts: 14
Joined: 01-November 11
Gender:Male
Location:Queens, NY

Posted 11 April 2013 - 11:25 PM

Here's the initial test. Was using the stock GT barrel .691 and the Valken Redemption Winter Formula was boring around .685. You'll see there wasn't a much of a increase in velocity regardless of the overbore and it was jumping around a bit. Will try this again after the GTi valve has been broken in a bit more.

http://youtu.be/TYgZNlqZZJQ

#4 dirtraven

Newbie

Group: Members
Posts: 38
Joined: 21-December 11

Posted 30 May 2013 - 09:23 AM

you're not gonna see much a dramatic improvement in efficiency as oppose to more reliability since the Gti valve now has a groove where the initial o-ring sits in as oppose to the original valve where it can move. Plus the GTi is now Pooty Spring ready so you don't have to have your valve modded by Pooty.