[The Desacrator]

Can someone measure their CP barrel back(for 2 piece barrels) and tell me how much in inches? I need to know so I know how long to get the front for my pump(I don't like freak Jr front's as much as CPs)

[Pizzaluvr]

It's 5-6". The back of the threading on the tip though(the rearmost thread where it screws in) is 5" from the back of the barrel.

Are you trying to put a cp tip on a Freak back? Your the first person I've seen that likes the CP fronts.

[The Desacrator]

Pizzaluvr, on Oct 16 2008, 04:40 PM, said:

It's 5-6". The back of the threading on the tip though(the rearmost thread where it screws in) is 5" from the back of the barrel.

Are you trying to put a cp tip on a Freak back? Your the first person I've seen that likes the CP fronts.

I'm not trying. I've done it. And it works flawlessly in my opinion(with good paint). bad paint might lead to breaks when it hits the insert.There is like 2-3~ millimeter gap between the end on the barrel and the insert. You have to push it just a little bit father so the insert makes contact with the back of the front.
So not including the threading, it is 5 inches?

[Pizzaluvr]

About. I don't have a ruler to check it out though.

EDIT: I know.. I just bumped a 2 week old thread.

[Woodsballer117]

I think its 5 1/2 inches long.