My journey with the rainmaker
Posted 17 April 2012 - 07:20 PM
The board is disconnected to the 4 way, no battery harness, and no shroud. I figure I may as well finish what the guy started.
Feel free to help me out along my endever, as I will probobly need it
Picture at the start
This will be my journey through which I hope to make a functioning rainmaker
Day 1: Rainmaker arrives, in pieces. I believe this is how the wiring goes, I need to buy a 9 volt batterey harness. Can anybody verify if this is correct?
Posted 17 April 2012 - 08:25 PM
Honestly, I would try MCB over TechPB for something like this.
Posted 17 April 2012 - 10:55 PM
The wiring harness:
-the button switch is the trigger switch and it's correct
-those 2 black wires do connect to the mac valve
-the on/off switch you can just splice into the either the negative or the positive of the battery pack. Mine is spliced into the positive.
Posted 30 April 2012 - 03:11 AM
How's your main pressure? How's the valve condition?
It's basically a backwards sheridan-style valve in there.
PUMPPB.COM TIGHTSTICK - Custom LAPCO 1-piece underbore barrel! SALE!
PUMPPB.COM - Pump paintball forums
HawaiiPB.com - Paintball forums for the state of Hawaii
HawaiiPB/PumpPB - Our videos
Posted 02 May 2012 - 07:25 PM
I'd personally replace the o-rings inside the whole marker, there is a pretty good chance that they are over 8 years old.
Does the gun cycle?
This post has been edited by cocker addict: 02 May 2012 - 07:26 PM