TechPB
Help
ok so when you pull the trigger it won't shoot but the light blinks but when you keep hitting it after about 15 hits in a row it starts firing and when you stop firing the same thing happen its not the battery tried new ones and different brands and i lubed everything what is wrong with it anything will be appreciated
Thanks
Page 1 of 1
Whats wrong with my Ion?
#3
WiscoBaller 
- Master Member
-
- Group: TechPB Players Club
- Posts: 2,655
- Joined: 11-August 10
- Gender:Male
Posted 03 November 2012 - 07:31 PM
have you dissassembled the noid? Sometimes the noids gum up and it takes a few shots to get them to cycle properly. It could also be the coil on the noid going bad. I would attempt to set the trigger adjustment for the board switch further back, see if that changes it, and if not, the noid would be my next guess.
University of Wisconsin Whitewater Paintball Club
Sponsored by KEE, H2 Paintball, Empire
The Hooligans Paintball Team
Bob Long Victory Ripper Dye Rotor Dye Throttle 70/4500
Bob Long Ripper FST
Sponsored by KEE, H2 Paintball, Empire
The Hooligans Paintball Team
Bob Long Victory Ripper Dye Rotor Dye Throttle 70/4500
Bob Long Ripper FST
#4
andrewthewookie
- Pull start me and I'm yours ;)
-
- Group: Moderator
- Posts: 19,691
- Joined: 22-August 09
- Gender:Female
- Location:Your bedroom
-
-
-
Posted 03 November 2012 - 07:31 PM
What's your dwell at? Do you have a QEV?
Hybrid SFT • 09 Impulse • HB REV-i • Macroless Mech Ion
Rotor • Grillz • PE 70/45 • Feedback - 21/0/0
Fear is the mind-killer
#5
Sydarm
- XTC + Ninja + Pinokio
-
- Group: TechPB Players Club
- Posts: 1,665
- Joined: 19-June 11
- Gender:Male
- Location:Oviedo, FL
Posted 03 November 2012 - 10:22 PM
Check the above issues, and also be absolutely certain that you have a brand new & premium 9v battery installed.
edit: Is it only a stock Ion board? Perhaps FSDO issue?
edit: Is it only a stock Ion board? Perhaps FSDO issue?
This post has been edited by Sydarm: 03 November 2012 - 10:22 PM
#6
member
- Newbie
-
- Group: Members
- Posts: 19
- Joined: 14-November 12
Posted 04 November 2012 - 12:07 AM
Aulldeath, on 03 November 2012 - 07:15 PM, said:
Does it have a stock board?
no it has a cp 14 inch barrel
WiscoBaller, on 03 November 2012 - 07:31 PM, said:
have you dissassembled the noid? Sometimes the noids gum up and it takes a few shots to get them to cycle properly. It could also be the coil on the noid going bad. I would attempt to set the trigger adjustment for the board switch further back, see if that changes it, and if not, the noid would be my next guess.
i could try that and before it starts firing theres like an air gap like a shot starts and fails
Share this topic:
Page 1 of 1