Jump to content


Photo

Spyder Hammer Velocity Issues


  • Please log in to reply
4 replies to this topic

#1 Salvation

Salvation

    Sophomore Member

  • Members
  • PipPipPip
  • 537 posts
  • Gender:Male
  • Location:Sheridan, IN


Posted 09 July 2010 - 10:30 PM

Ok so I picked up an old Spyder Hammer for cheap. It shoots great but the Velocity is all over the place.

Ive put in new springs but I still get 30+ difference in velocity shot to shot and it tends to shoot hot more often than not. Makes no difference if I run HPA or CO2. I still get the spikes and velocity inconsistancies.

Any suggestions would be greatly appreciated.

Kev
Indiana Member #"Old Fart"
SAS-Indiana
Central Indiana
http://saswoodsball.com/
http://www.sasmilsim.com/

#2 pinkyy

pinkyy

    I'm slightly alive...

  • Retired Staff
  • PipPipPipPipPipPip
  • 3,243 posts
  • Gender:Male
  • Location:Brantford Ontario Canada

Posted 25 July 2010 - 06:19 PM

the best i can say is to take the lowest spring you have and cut it, smaller only by a bit, then try it..
To those brave men and women who fought for their lives, who fought to save our lives. We stand at attention in honor of our fallen ones.

Lest We Forget those who fought so hard, never be forgotten. Never take anything for granted, always remember always respect.. ♥


Citrus Connection Scenario Paintball. Me, Crazy Dancing Pink Pant, Crazy Eyed Canadian..

#3 Danny D

Danny D

    Senior Member

  • Members
  • PipPipPipPipPip
  • 2,036 posts
  • Gender:Male
  • Location:Canada

Posted 12 August 2010 - 09:59 PM



Make sure a proper o ring is on the hammer. Buna 70, not buna 90

#4 Xmas Asn

Xmas Asn

    ╭∩╮(︶︿︶)

  • Members
  • PipPipPipPipPip
  • 2,184 posts
  • Gender:Male
  • Location:Barstow, Ca

Posted 17 August 2010 - 04:23 PM

Try a different barrel. I had a Spyder Victor and a mix of bad paint and that cheap barrel I was getting -+20 or 25. Also check your valve and pin. Make sure its clean.

#5 WhatsHisFace

WhatsHisFace

    You're Not Alone, Except in Real Life.

  • Members
  • PipPipPipPipPipPip
  • 4,990 posts
  • Gender:Male
  • Location:Canada

Posted 06 November 2010 - 08:37 PM

Very possible that you're getting partial rollouts. Try a small bore barrel, or if you're cheap use tape or nail polish as a detent.




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users