Jump to content


Photo

Stock regulator


  • Please log in to reply
1 reply to this topic

#1 fatefuledge

fatefuledge

    Newbie

  • Members
  • Pip
  • 11 posts
  • Gender:Male

Posted 04 April 2011 - 09:06 AM

Stock regulator doesn't screw in all the way because of the fitting hitting the trigger guard. Is there an adapter available? I was hoping to find a slight angle forward design.

Edited by fatefuledge, 04 April 2011 - 09:07 AM.


#2 OOG671

OOG671

    Master Member

  • Members
  • PipPipPipPipPipPip
  • 3,083 posts
  • Gender:Male

Posted 04 April 2011 - 08:43 PM

Not sure about an adapter.

What you'll need to do is open your grips, remove the battery, and then carefully unplug the battery harness and solenoid from the board (be careful because the prongs on these wires are fragile). Then unscrew the two screws holding the grip frame. Once you've removed the grip frame. Screw your regulator in....and then reassemble your grip frame again be careful with the wires.

Or if you want just buy an aftermarket reg like CP with the fitting at the bottom of the regulator.
Pro Jerseys FST Feedback:http://www.techpb.co...showtopic=61562
Muppet #72, Christian Baller




2 user(s) are reading this topic

0 members, 2 guests, 0 anonymous users