Jump to content


Axe feedneck

  • Please log in to reply
4 replies to this topic

#1 X Soul Reaper

X Soul Reaper


  • Members
  • Pip
  • 16 posts
  • Gender:Male
  • Location:New York

Posted 07 July 2011 - 11:10 AM

I've had my axe for couple months now i have the oled board installed next upgrade is the virtue laser eyes and new bolt. I've seen people with the nano feedneck on the axe but no instructions on how to install it. If anyone knows how i would appreciate the instruction to do it. Don't want to mess her up.

Thanks in advance




    Sophomore Member

  • Members
  • PipPipPip
  • 561 posts

Posted 12 July 2011 - 01:52 AM

take the lever and bolt off the feedneck. put a fitting piece of pvc that fits snug in the feedneck. wrap the feedneck in a cloth (something durrable preferably) to save the annodizing. now grip firmly with plyers and carefully turn counterclockwise until it screws out

Edited by MURPHofPBP, 12 July 2011 - 04:12 PM.


#3 Algae


    megasuperawesomelazerbeam railgunofepicdoomandstuff

  • Members
  • PipPipPipPipPipPip
  • 3,621 posts
  • Gender:Male
  • Location:New Jersey

Posted 19 July 2011 - 11:03 PM


Algae's Feedback

Empire Axe Overview

First post? Awesome, but if the OP is asking a question, that's just being an ass

#4 drwoolynipplez


    Sophomore Member

  • Members
  • PipPipPip
  • 464 posts
  • Gender:Male
  • Location:Hampshire IL

Posted 11 August 2011 - 07:11 PM

i loveeee you ^^

i loveeee you ^^
setup: empire axe, 68/45 dxs, pinokio
Feedback +6/0/-0

#5 Jozeph



  • Members
  • Pip
  • 20 posts
  • Gender:Male

Posted 15 October 2011 - 04:44 AM

Wish mine came off that easy, I swear it was the only thing that was tight when I bought the gun. Destroyed the stock feedneck taking it off.
R.I.P Borg
"We who dawn the Pants were born of greatness... such is why the pants have been given! We accept these Pants with pride, and we wear them so!"

#6 Cromer611



  • Members
  • PipPip
  • 57 posts
  • Gender:Male
  • Location:Denver Colorado

Posted 17 May 2012 - 02:44 AM

Lol, take out your bolt guide, take out the two detents, Take off the clamp/bolt/brass thread bearing.
Grab your lighter and a Allen key that will fit through the holes in the clamping feed neck. Warm up the feed neck where it meets the body with your lighter. Waving it on either side of the feed neck. You will see the lock tight begin to weap out of the seem. Now is the time to loosen with your Allen key as a lever.
Some heat on lock tight does amazing things, almost like it was designed that way /facepalm.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users