Jump to content


Photo

Lurker Bolt on the Axe


  • Please log in to reply
1 reply to this topic

#1 empireaxeattack1229

empireaxeattack1229

    Member

  • Members
  • PipPip
  • 66 posts
  • Gender:Male

Posted 27 December 2011 - 11:11 AM

Just need some clarification here. So you adjust the regulator screw (hole were you put allenkey on front of the relay asa). Then you lower dwell and what does it mean by cycling poorly then cycling crisp. Next you adjust the velocity screw whichever way goes out until the velocity drops a little or a lot? Finally is the high pressure regulator the relay asa and i do the same thing as in part 2. Thanlyou

#2 SNAKESNIPER

SNAKESNIPER

    Junior Member

  • Members
  • PipPipPipPip
  • 859 posts

Posted 27 December 2011 - 07:20 PM

I read on the Nation to do 170PSI, 4ms dwell.

I shot some week-old paint in the cold with my Lurker'd Axe on these settings, and it only broke one ball shooting around 15bps (semi).
As a matter of fact, it may have just cracked a shell because there was a just a touch of paint inside the barrel when I was done almost 3 pods.

Edited by SNAKESNIPER, 27 December 2011 - 07:26 PM.





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users