Jump to content


Photo

Empire Prophecy problem?


  • Please log in to reply
5 replies to this topic

#1 gogpaintballer

gogpaintballer

    Junior Member

  • Members
  • PipPipPipPip
  • 868 posts
  • Gender:Male

Posted 10 February 2012 - 05:52 PM

Today I put my Empire Prophecy on a DP G4 and the marker dry fired, with paint in hopper and all I had to use the rip drive to get a ball off. When the hopper turns on it spins and flashes different colors. Then keeps flashing green every 2-4 seconds. I bought it used off of ebay. Whats the issue?
I am HOAGIESON!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

#2 andrewthewookie

andrewthewookie

    Shaaaaaaaaaaaaaaaaarks :(

  • Chat Coordinator
  • PipPipPipPipPipPipPipPip
  • 21,982 posts
  • Gender:Female
  • Location:Your bedroom


Posted 10 February 2012 - 05:54 PM

Have you tried new batteries?

RebelSignaturejedicode-1.jpg
Hybrid SFT 09 Impulse HB REV-i Macroless Mech Ion
Rotor Grillz PE 70/45 Feedback - 23/0/0

Closer & Angel A1 F/S/T


#3 gogpaintballer

gogpaintballer

    Junior Member

  • Members
  • PipPipPipPip
  • 868 posts
  • Gender:Male

Posted 10 February 2012 - 10:55 PM

I put in brand new ones in when it arrived.
I am HOAGIESON!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

#4 The Crazy Cow

The Crazy Cow

    Sophomore Member

  • Members
  • PipPipPip
  • 463 posts
  • Gender:Male
  • Location:Oshawa Ontario, Canada

Posted 14 February 2012 - 11:03 PM

reset it to factory settings maybe.
Moo.

#5 gogpaintballer

gogpaintballer

    Junior Member

  • Members
  • PipPipPipPip
  • 868 posts
  • Gender:Male

Posted 21 February 2012 - 07:46 AM

How do I reset it to stock settings?
I am HOAGIESON!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

#6 Atomicvole

Atomicvole

    Newbie

  • Members
  • Pip
  • 29 posts
  • Gender:Male
  • Location:Bloomington, IL

Posted 27 February 2012 - 10:03 PM

I am assuming you ahve a V1 or V2 not one of the new Z2 Prophecy?

Check that the back plate is not jammed against one or both of the buttons.
Good using new batteries.

As for settings down load the manual for it, that is your best source of info:
http://www.paintball...ual_w_cover.pdf

Page 15 has the default values.

At times it may seem you need an engineering degree to get them back together, but it is not more difficult than reassembling a Rubic's Cube :D

Here are a the videos on disassembly and reassembling the loader:
http://www.paintball...om/?page_id=181

Edited by Atomicvole, 01 March 2012 - 10:41 PM.





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users