Jump to content


Photo

first shot and barrell breaks.


  • Please log in to reply
3 replies to this topic

#1 paul33kane

paul33kane

    Sophomore Member

  • Members
  • PipPipPip
  • 473 posts
  • Gender:Male
  • Location:barrie ontario canada.

Posted 22 October 2012 - 12:23 PM

when i turn on my envy blackheart the first one or sometimes two shots little puffs are heard and no shot but then shoots fine, figured it was the fsdo so made sure the marker is set to the hpa setting which it is still having the same problem my dwell is at 27 ms as i have no qev.

Also i have used both stock barrell and other barrells but having some barrell breaks not sure if its the paint or just the rate of fire is too high the marker is set for 12.5bps as with no qev i dont wanna go higher any help would be greatly appreciated thanks.

#2 tyronejk

tyronejk

    Member

  • Members
  • PipPip
  • 92 posts

Posted 28 October 2012 - 10:24 AM

Are you getting barrel breaks or chops? Or is your loader feeding too fast?

If they are barrel breaks, check the bore size and overbore a little. If it's chopping, try lowering the bps. If it's your loader, slow it down a little.

#3 WiscoBaller

WiscoBaller

    Master Member

  • TechPB Players Club
  • PipPipPipPipPipPip
  • 2,655 posts
  • Gender:Male

Posted 28 October 2012 - 06:43 PM

a lot of times the first few puffs are the solenoid being slow, take it apart and relube it, then it should work.

University of Wisconsin Whitewater Paintball Club
Sponsored by KEE, H2 Paintball, Empire
The Hooligans Paintball Team
Bob Long Victory Ripper Dye Rotor Dye Throttle 70/4500
Bob Long Ripper FST


#4 paul33kane

paul33kane

    Sophomore Member

  • Members
  • PipPipPip
  • 473 posts
  • Gender:Male
  • Location:barrie ontario canada.

Posted 17 November 2012 - 02:19 PM

never mind i figured out the paint was to big for the barrel cant believe the paint is so big i was using a stock barrell bore is .690 and the paint was breaking and it was just plus 7 degrees lol go figure havent seen paint this big in a while lol




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users