Jump to content


Photo

T2 acting strange


  • Please log in to reply
7 replies to this topic

#1 That_guy097

That_guy097

    Member

  • Members
  • PipPip
  • 79 posts


Posted 12 March 2013 - 04:34 PM

Ok so the last few times iv had my ccm t2 out on the feild it's been acting funny.

My set up is my t2, 68/45 (low pressure output), and either a rotor or grav feed.

Problem #1 - when I get on the AT the first 4 shots are good then the velocity drops like crazy. Like the paintballs barely roll out the barrel.
My thinking is that the low pressure output might be the cause but tried it with a hp tank and same thing.

Problem #2 - happened after problem 1. My velocity keeps spiking. Like I shoot 270-270-308-245 and it starts to jump. But now my AT is fine. Like no shots dropping.

Neither problem happens at the same time. It's one or the other. Any ideas?

#2 riddler

riddler

    Senior Member

  • Members
  • PipPipPipPipPip
  • 1,082 posts
  • Gender:Not Telling

Posted 12 March 2013 - 05:19 PM

Service your reg.

#3 Klub

Klub

    i haz a pickle

  • TechPB Players Club
  • PipPipPipPipPipPip
  • 4,875 posts
  • Gender:Male
  • Location:alaska


Posted 12 March 2013 - 10:48 PM

sweet spot the reg.
And make sure you aren't getting partial rollouts.

Edited by Klub, 12 March 2013 - 10:48 PM.


#4 Rotozip2

Rotozip2

    BRO do you even autococker?

  • Members
  • PipPipPipPipPipPip
  • 3,432 posts
  • Gender:Male
  • Location:St. Louis

Posted 13 March 2013 - 01:12 AM

Are you adjusting via the IVG or the regulator?

I never get wipers, blood is hard to wipe off.


Do it with style ~ Total Grief

I like autocockers and autococker accessories.

#5 XxJellyFilledxX

XxJellyFilledxX

    Lead Farmer.

  • Chat Moderator
  • PipPipPipPipPipPip
  • 3,337 posts
  • Gender:Male
  • Location:Maine


Posted 13 March 2013 - 06:36 AM

1.Service reg/sweet spot
2.reset ivg and chrono
3.time you AT its possible its off and causing air to go up the feedneck causing a decrease in velocity.

"You can't break a man the way you break a dog or a horse. The harder you beat a man, the taller he stands. To break a man's will, to break his spirit, you have to break his mind."

 


#6 That_guy097

That_guy097

    Member

  • Members
  • PipPip
  • 79 posts


Posted 13 March 2013 - 07:16 AM

Haven't changed anything. It's all from the factory. It chrono'd 275 perfectly my first few times using it and I never changed it.

Ivg is at the back of the marker? Like the lower tube ?

#7 madsnipes

madsnipes

    CARNAGE 3!!!!!!!

  • Members
  • PipPipPipPipPipPipPip
  • 5,055 posts
  • Gender:Male
  • Location:In one of those "High-Tech" caves with Wi-fi

Posted 13 March 2013 - 09:19 AM

Haven't changed anything. It's all from the factory. It chrono'd 275 perfectly my first few times using it and I never changed it.

Ivg is at the back of the marker? Like the lower tube ?

yes, back it out until its flush.
then turn it 1.5 turns in and adjust your regulator until it peaks (aka sweetspot it)
and set your velocity with your IVG.

#8 drg

drg

    Junior Member

  • Members
  • PipPipPipPip
  • 852 posts


Posted 13 March 2013 - 05:41 PM

note that the plastic thing at the very end of the lower tube is cosmetic
Keep your pump hand strong!
PUMPPB.COM TIGHTSTICK - Custom LAPCO 1-piece underbore barrel! SALE!
PUMPPB.COM - Pump paintball forums
HawaiiPB.com - Paintball forums for the state of Hawaii
HawaiiPB/PumpPB - Our videos




2 user(s) are reading this topic

0 members, 2 guests, 0 anonymous users