Jump to content


That's not supposed to happen...Ego 11 LPR spring bent

  • Please log in to reply
3 replies to this topic

#1 badger nine

badger nine

    Senior Member

  • Members
  • PipPipPipPipPip
  • 1,669 posts
  • Gender:Male
  • Location:VA

Posted 20 May 2013 - 01:43 PM

So I was cleaning the LPR on my CSL when I took out the piston and out popped the front spring, weirdly bent.

Easy and cheap enough to replace it, but I was wondering if anyone would have insight on how this happened?

My guess is that it wasn't properly aligned when I put it in after a previous disassembly, or too much of an adjustment on the LPR, even though I haven't any issues with velocity.


Edited by badger nine, 20 May 2013 - 01:53 PM.

"In life, fuck whatevery one else says, screw what they think, and do what makes you happy." - Mike

Posted Image

#2 tallsmallboy44


    Space Cowboy

  • Members
  • PipPipPipPipPipPipPip
  • 5,402 posts
  • Gender:Male
  • Location:Ohio

Posted 20 May 2013 - 07:52 PM

Probably put in slightly off when assembled at some point.

fuck yolo

Feedback 2/0/0   Buy my shit here: http://www.techpb.co...-bob-long-vcom/

#3 OEFVeteran


    TechPB's Resident Angry Veteran

  • Retired Staff
  • PipPipPipPipPipPip
  • 4,031 posts
  • Gender:Male
  • Location:Norwood, Mass

Posted 24 May 2013 - 07:34 PM

i've seen high strength MTB shock springs do this when they get compressed too much too fast... usually a weight issue that causes the spring to "slip" like that when compressed
Shocktech Aftershock SFL team cocker, serial number 1
Mini Orracle pump, Eclipse internals, Sanchez Machine pump kit and grip frame
Mossberg 500 ZMB

OSG Paintball biggest and best field in NH... show them some love

"I wish I had 2000 feet. So i could shove 500 of them up each of your asses!!!!" Red Foreman

#4 Soundwave


    I win paintball.

  • TechPB Players Club
  • PipPipPip
  • 662 posts
  • Gender:Male
  • Location:Melbourne, Australia

Posted 31 May 2013 - 02:48 AM

All the springs can bend under the right circumstances. Normally it's indicative of a problem during assembly.

Posted Image

My Moderator Application: http://www.techpb.co...howtopic=196721

1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users