The macroline would go in and out of the side rail mount slot to keep it close to the gun. I'm still deciding on how to implement the asa drain valve (i have the inline one). The qloader would be mounted on a picatinny about 4 inches closer to the reg, the foregrip is my ghetto rig that allows me to move the qloader between various guns easily. Tank is a 17ci and yields about 150 shots. I also have a 22ci tank with a rubber butt.
The rear asa is a RAP4 custom 98 stock tank piece, but it does not fit in the supplied 98 mount that comes with emc, the groves on emc plug are too deep, so I ground a hole in the back of the "endcap" plug that comes with EMC and heat-fitted the new asa into it, with a pin thru it to prevent spinning of the asa during mounting of the tank.
Etha has the ape rampage board and I can toggle up to 35 bps and the qloader keeps up, but empties the qloader in 3-4 seconds. I will keep the bottom ASA mounted which will allow me to pop in a macroline and Rotor for speedball.
Next post: magfed A5. Maybe even with custom first strike mag and magwell
Edited by wartex, 31 May 2013 - 06:53 PM.