Jump to content


Photo

Empire axe board problems


  • Please log in to reply
1 reply to this topic

#1 legitpro808

legitpro808

    Living the HI life

  • Members
  • PipPip
  • 299 posts
  • Gender:Male
  • Location:Honolulu, HI

Posted 19 June 2013 - 03:07 AM

So I just got in the shockwave board for my axe from kee and it seemed to work pretty good. But when I was on the field and tried to turn it on, it glowed red, then flashed all of the colors like it was going into programming mode. The screw on the trigger is not pressing down on the microswitch so its not that. Any help would be appreciated.
Axe Conglomerate v3
Repping the 808 State! Oahu Grown


#2 Cj R

Cj R

    TechPB's Grazi

  • Members
  • PipPipPip
  • 695 posts
  • Gender:Male
  • Location:North Carolina

Posted 19 June 2013 - 05:02 AM

With the shockwave board, holding in the trigger and powering it on will put it in programming mode. Touch nothing on the marker but the power button, press and hold it until the LED changes. If your marker's in programming mode again, loosen up your trigger screws a bit as they might be too tight. Repeat. If your Axe is STILL in programming mode, you might have a crap board. Call up KEE and ask them what's up and if that's the case if they can send you out a new board.

Feedback http://www.techpb.co...howtopic=219021 2/0/0
The best customer service is the one you don't have to call in the first place.





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users