Jump to content


Photo

Etek 4 rebuild


  • Please log in to reply
7 replies to this topic

#1 AlPowPaint

AlPowPaint

    Newbie

  • Members
  • Pip
  • 41 posts

Posted 19 May 2014 - 06:57 PM

Hi I just got my etek 4 and I took it apart to clean it, i took out the rammer housing the one that holds the LPR but i didn't look which way is up or down. So now i have the housing and it has two sides that it can go in so that the screw that holds it can keep it in. One side is just a dimple and the other side is a full hole going in. So I'm wondering if someone could tell me which way to put it in. If it helps in the manual it sais  "Ensure that the outlet port is facing upwards and the valve plug is facing downwards" and then a picture but its black on black so i cant tell. 

Thanks



#2 BurningPlaydoh

BurningPlaydoh

    Blow-dough'ed

  • Members
  • PipPipPipPipPipPipPip
  • 5,894 posts
  • Gender:Male
  • Location:Twin Cities, MN

Posted 19 May 2014 - 07:11 PM

Go look at the parts diagram(s) in the manual.

#3 AlPowPaint

AlPowPaint

    Newbie

  • Members
  • Pip
  • 41 posts

Posted 24 May 2014 - 07:09 PM

Go look at the parts diagram(s) in the manual.

I did but its black on black so i cant tell.



#4 Forrest99

Forrest99

    got that rockin' summer bod

  • Members
  • PipPipPip
  • 394 posts
  • Gender:Male
  • Location:massachusetts


Posted 24 May 2014 - 10:18 PM

Why did you pull it apart in the first place?

Any one with a B2k pds board?


#5 BurningPlaydoh

BurningPlaydoh

    Blow-dough'ed

  • Members
  • PipPipPipPipPipPipPip
  • 5,894 posts
  • Gender:Male
  • Location:Twin Cities, MN

Posted 25 May 2014 - 12:19 AM

Why did you pull it apart in the first place?

Literally the first line of his post...

Try looking at the LPR disassembly/assembly section of the manual.

Edited by BurningPlaydoh, 25 May 2014 - 12:21 AM.


#6 Cookybiscuit

Cookybiscuit

    Schadenfreude Fanatic

  • Members
  • PipPipPipPipPipPipPipPip
  • 15,640 posts
  • Gender:Female
  • Location:Mexico


Posted 25 May 2014 - 11:42 AM

Putting it in the wrong way wont damage it, but anyways the side with the large hole in it faces upwards.


Awarded: " the biggest dumbass on this forum" 2012


#7 pb2332

pb2332

    Member

  • Members
  • PipPip
  • 118 posts

Posted 16 June 2014 - 12:55 AM

I know this thread is dead but with my etek 4 the smaller hole is the correct way for the ram housing to fit

#8 Frogman

Frogman

    Member

  • Members
  • PipPip
  • 58 posts

Posted 03 July 2014 - 11:10 PM

Ask a certified air smith best bet




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users