Jump to content


Pimpin_Ace

Member Since 15 Mar 2009
Offline Last Active Mar 22 2011 06:23 PM
*****

Posts I've Made

In Topic: having problems with my etek

25 February 2011 - 09:49 PM

Maybe bolt pin not in the rammer?



have you ever taking the noid apart? I had a similar issue when i took the noid apart and accidentially put the center part of the noid backwards. If you havent taken it apart, then i would check o rings and top hats to make sure there are no leaks, check the LPR, check noid conections, and thenyou could also check the board to see if thats bad. Hope that helps a little man gl

Jordan

In Topic: E2 frame question

25 February 2011 - 09:38 PM


thats sounds like it, have you tried a punch to tap it out?

Dont know why that would be stuck if the screw is out



un fortunatly i dont have a punch set, i've been reduced to suing an allan key and and some old steel bar stock. lol

but at least i know it "should" come out now. thanks.



Try finding a small screwdriver that is the same size or a little smaller and use that to hammer the pin out, the pins sometimes are a very tight fit for the hole. You are gonna have to hit this thing pretty hard, but if you lay down some towls or something the pin will eventually get pushed out the other end. You could also try putting a little gold cup oil ( or anything like it) and let it drip through to lube up the pin.

Jordan

In Topic: 06 virtued etek ego, full freak, and v35 for sale

08 November 2010 - 04:49 PM

omg 250 shipped will buy 2day


gun sold, mods could you please close this thread

Thanks,
Jordan

In Topic: 06 virtued etek ego, full freak, and v35 for sale

20 October 2010 - 04:17 PM

Bump and PRICE IS LOWERED!!

In Topic: 06 virtued etek ego, full freak, and v35 for sale

20 October 2010 - 08:48 AM

bump