Jump to content


obsidianjeff

Member Since 23 Mar 2009
Offline Last Active Mar 12 2014 05:00 PM
*****

Topics I've Started

advice for removing stubborn screws

28 February 2013 - 02:30 PM

the screws holding the dovetail asa on my gen 3 timmy are pretty much rusted on, anyone have advice for getting them off? not a huge fan of using heat in this situation to help it out because i'm lazy and don't want to take out all the nearby internals, and because i'm not sure how much it would actually help.

ps. this is what me and the screws did to a new exalt allen key
Posted Image

picture of said screws
Posted Image

chip and scuffs

25 February 2013 - 03:16 PM

Hey ninja, have a small chip in the clear coat, as well as some scuffs in the clearcoat. going to be sending it in for rehydro-reg-swap soon, just wanted to get the O.K. from you guys. no threads are exposed on the tank, so I think it should be good, also got a picture of the stamp on the side because I figured it would help or something.

tank sticker
Posted Image

scuff
Posted Image

other scuff
Posted Image

chip
Posted Image

wont let me renew pc membership

23 November 2012 - 01:18 AM

when I try to pay the invoice I'm taken to a page that reads "[#20X111] We are unable to process a purchase amount that is so high. Please contact an administrator for assistance."

halp please, if I need to PM someone in particular i'll do that, but i awnt to be in the players club and i assume you guys would like mah moneys

2011 g6r not bleeding

30 September 2012 - 07:30 AM

my 2011 g6r isn't bleeding when I unscrew the pin, is there on oring or something I should check to fix this?